Once you give us a call, we can get the design shipped as soon as you are ready!

The process to install your design into your patio/driveway takes only three steps and can be done by any hardscaper or even a homeowner looking for a project!

​

1. Draw a circle equal to your design size

2. Cut the circle and remove the pavers inside.

3. Place the PAVERART Pavers in

4. Sweep polymeric sand in the joints.

5. Ensure that there is no polymeric sand left on the pavers and spray water on it to activate the sand.

​

Then enjoy your new design!​

If you need any questions before, during, or after installing, just call us up and we will answer anything you need!